Toggle Nav
Water-Washable 3D resin, Gray, 1L
SKU
WS-3D-Gray-1L
In Stock
48.95EUR 39.00EUR
- Buy 2 for 43.93EUR 35.00EUR each and save 10%
Water Washable 3D printing resin, Gray, 1L, 405nm UV Cure
No IPA, NO detergent, 100% clean by water
Property similar to ABS like resin
Low odor, less irritating
Slightly soluble in water, no dangerous to environment
Non VOC, RoHS certificated
| Technical specification | |
| Flexural modulus of elacticity | 924 Mpa |
| Impact strenght |
128 (J/m) |
| Hot deformation temp | 80C |
| Linear shrinkage | 1.05-1.35% |
| Tensile strenght | 22.5 Mpa |
| Tensile modulus | 385 Mpa |
| Elongation at break | 6% |
| Hardness (Shore D) | 80-85C |
| Viscosity | 150-350MPa-s |
| Printing parameter | |
| Printing time | For LCD printer, bottom layer 30-70s and each layer exposure time 4-12s, for example, layer thickness 50 micron on Anycubic printer, base 50s while each layer 8s. For DLP printer, bottom 5-15s and each layer 1-5s. |
| Cleaning and post-curing | Cleaning with flush water and brush it gently with a soft brush, and then drying it with cold air. |
| Post-curing | 1. The curing time is proportional to the volume of the work piece and inversely proportional to the optical power of the curing chamber. Example: 100 watt LED curing box, jewelry jobs is recommended to be cured with soaking in water for 20-30 minutes. 2. The post-cure time of dental casting resin, dental non-casting resin and jewelry mold resin shall not more than 5 minutes. 3. Work-pieces should be in the water during post-curing to prevent deformation especially for dental and jewelry. 4. Don’t forget to use cool air to dry it after post-curing. |
